A VIRTEX4 LX40 FPGA is used on the TRBv2.

FPGA registers

r/w adress bits
r 0 31-26 not used ADO_LV 25-0
r 1 31-lvl2 busy 30:lvl1_fifo_wr_en 29-16: lvl1_fifo_counter 15:lvl1 or lvl2_is_busy 14:lvl1 busy 13-4:how many words in lvl1 buffer 3-0:TDCD,C,B,A error
r 2 31-27:not used 26-24:lvl2_debug:001: IDLE
010: READOUT_WORD1
011: READOUT_WORD2
100: SAVE_EVENT_SIZE
101: SEND_DATA1
23-20:LVL1 state:
x"1": IDLE
x"2"-x"5": SEND_LVL1_TRIGG_1-4
x"6": WAIT_FOR_TOKEN
x"7"-x"a": SAVE_ADD_DATA_1-4
x"c": SEND_LVL2_TRIGG
19-18: delay trigger FSM: 01: IDLE
10: DELAY_1
11: DELAY_2
15-0:how many words in event
r 3 31-0: lvl1_buffer_out
r 4 31-28: not used 27-24: LVL1 CODE 23-16: LVL1 TAG 15-12: not used 11-8:lvl1_code -internal 7-0: lvl1 tag minus 1
r 5 31-24:how many lvl2 busy ended 23-16:how many times lvl2 started 15-8:how many times token was received 7-0:how many times lvl1 started
r/w 6 31-24:additional delay time for trigger to TDC's 10ns resolution 23-16:how many add data(counters) 15-10:reserved 9:eneble SPI for RPC 8:enable ext. trigger 7:enable self trigger 6:enable tdc clock(trbva) 5:dsp boff(active low) 4:dsp reset(active low) 3:dsp bm and bms 2:enable test signal trigger(2)-100Hz- 1:enable test signal trigger(1)-100Hz 0:enable JTAG for TDC
r/w 7 31-12:reserved 11:spi_cs_d 10:spi_sdo_d 9:spi_sck_d 8:spi_cs_c 7:spi_sdo_c 6:spi_sck_c 5:spi_cs_b 4:spi_sdo_b 3:spi_sck_b 2:spi_cs_a 1:spi_sdo_a 0:spi_sck_a
r 8 31-4:reserved 3:spi_sdi_d 2:spi_sdi_c 1:spi_sdi_b 0:spi_sdi_a
r/w e 31-16:not used 15-8:trb data version 7-4:enable test signal b MB3-0 3-0:enable test signal a MB3-0

FPGA interfaces

Etrax

The Etrax is sending a mode in which it wants to operate(R/W) with the first strobe. If it is the "read mode" then it sending only 32 bit address,if it is the "write mode" it sends also 32 bit data. To read data from the FPGA registers one has to use the following command: ./rwv2 r 0 1 : where rwv2 is the read write program, r - mode, 0 - which device(FPGA), 1 - address inside the device.
For writing ./rwv2 w 2 ab 01234567 : where w - mode, 2 -device number(SDRAM), ab- address, 01234567 - value to write

Device numbers:
0-FPGA
1-DSP
2-SDRAM
3-Add on board - not existing
4-SFP - not existing
...

* Etrax FS and FPGA protocol:
EtraxFS and FPGA protocol

All devices are accessible by the ETRAX-FPGA interface. It can be extended for future needs (add on interface, SFP ...)

* Connection between interfaces:
Connection between interfaces

DSP

All needed information should be found on: http://www.analog.com/processors/tigersharc/technicalLibrary/manuals/index.html Currently, the DSP interface is used as a host interface between DSP and FPGA. The main signals are HBR - host bus request, HBG - host bus grant, WRL,WRH - write , RD - read, BRST- burst, ACK - acknowledge. To start reading or writing the DSP has to leave the reset state: ./rwv2 w 0 6 30 Then it is possible to write or read:

./rwv2 r 1 0x1xxxxxxx

For accessing the Sharc, the offset address is 0x10000000, because the TigerSHARC DSP is a multi processor system (first device).

SDRAM

Now it is existing a simple entity just for checking if it is possible to write or read to SDRAM For reading : ./rwv2 r 2 0x110

http://download.micron.com/pdf/datasheets/dram/sdram/512MbSDRAM.pdf

TDC

This interface is for downloading the TDC measurements.
  • Parallel interface:
    Parallel interface

Optical and SFP

This interface will be use for trb net data transmition (2Gbit). There are entities available which are using this interface. From the SFP one can read out the temperature and the optical power.

Addo-on

For controlling and checking the status of add-on boards.

VULOM

To be done.

-- MarekPalka - 27 Jun 2007

ISorted descending Attachment Action Size Date Who Comment
inside_fpga.jpgjpg inside_fpga.jpg manage 92 K 2007-06-28 - 11:56 MarekPalka Connection between interfaces
protocol_final.jpgjpg protocol_final.jpg manage 92 K 2007-06-27 - 17:30 MarekPalka EtraxFS and FPGA protocol
tdcinterface.jpgjpg tdcinterface.jpg manage 93 K 2007-06-28 - 14:58 MarekPalka Parallel interface
Topic revision: r8 - 2008-07-23, MarekPalka
Copyright © by the contributing authors. All material on this collaboration platform is the property of the contributing authors.
Ideas, requests, problems regarding Foswiki Send feedback | Imprint | Privacy Policy (in German)