VME addresses for every given register

(currently it is a copy of pdf document.)

Address      Description
offset 
(hex)

80           Enable input
0            Delay value for PTI1
4            Delay value for PTI2
8            Delay value for PTI3
c            Delay value for PTI4
10           Delay value for PTI5
14           Delay value for TS
18           Delay value for VS
a4           Delay value for Beam signal
1c           Downscale value for PTI1
20           Downscale value for PTI2
24           Downscale value for PTI3
28           Downscale value for PTI4
2c           Downscale value for PTI5
30           Downscale value for TS
34           Downscale value for VS
38           Downscale value for local clock
3c           Width value for PTI1
40           Width value for PTI2
44           Width value for PTI3
48           Width value for PTI4
4c           Width value for PTI5
50           Width value for TS
54           Width value for VS
a8           Width value for Beam signal
58           OR on/off
5c           MUX 1 selection
60           MUX 2 selection
64           Scaler register PTI1 (read only)
68           Scaler register PTI2 (read only)
6c           Scaler register PTI3 (read only)
70           Scaler register PTI4 (read only)
74           Scaler register PTI5 (read only)
78           Scaler register TS (read only)
7c           Scaler register VS (read only)
8c           Scaler reset
b4           Scaler register Dead time (read only)
90           Enable MDC/TOF branch + Width value for MCD_TOF_out
94           Scaler channel selection for TOF and MDC
98           Scaler register for MDC (read only)
9c           Scaler register for TOF (read only)
84           Width for GT (output)
a0           PTI5 (mux2) and TS (mux1) alternate input
a4           High voltage inhibit dealy
a8           High voltage internal inhibit width
ac           High voltage external inhibit width
b0           Disable TS gating
b8           Scaler register PTI1 accepted (read only)
bc           Scaler register PTI2 accepted (read only)
c0           Scaler register PTI3 accepted (read only)
c4           Scaler register PTI4 accepted (read only)
c8           Scaler register PTI5 accepted (read only)
cc           Scaler register TS accepted (read only)
d0           Scaler register VS accepted (read only)
d4           Scaler register MUX 1 (read only)
d8           Scaler register MUX 2 (read only)
dc           Calibration trigger disable
88           Communication bus enable (TRB + DTU)
e0           DTU error

-- SergeyYurevich - 11 Apr 2008

This topic: DaqSlowControl > OutdatedPages > VULOM3Triggerbox > VMEAddressesForEveryGivenRegister
Topic revision: revision 1
 
This site is powered by FoswikiCopyright © by the contributing authors. All material on this collaboration platform is the property of the contributing authors.
Ideas, requests, problems regarding Hades Wiki? Send feedback
Imprint (in German)
Privacy Policy (in German)